CSI: Registered sensor subdevice: fsl_vadc The modules loaded at boot are MXC_VADC and m圆s_capture (VIDEO_MXC_CSI_CAMERA). In the doc file i.MX_6_Linux_Reference_Manual.pdf in the chapter 57 (VADC) in the 'Unit Test' part I found this:īefore running the unit test, make sure that the following modules are loaded:īUT no one of these modules exists in the kernel 3.14.28 This is my dts (the analog camera is connected to VADC_IN0 and GND)

I also think that part of the documantation is wrong in the pdf 'i.MX_6_Linux_Reference_Manual.pdf' downloaded in the documentation package 'fsl-yocto-3.14.28-1.0.0.gz' I think that everything is set fine but I cannot have a clean image returned. I would know how to use VADC input with Linux to have the stream of an analog camera. Thank you so much for any replies in advance.I'm using a board based on sabre-sd iMX6 SoloX. hence, why i'm asking for somebody's opinion, if you don't mind. i'm sick of downloading free programs that i've got to figure out how to work, only to find out that they don't do certain things after i've lerant how to use it. 'screen with message for a half a minute or so within a video', does anybody know another free program that does this as well as transitions? somebody suggested another free program for trasnsitions but i'm not sure if that program also could do this. I'm using avidemux but i've noticed another limitation with this program (no transitions), so does anybody know, if avidemux doesn't do this. so in a certain point in the video, i'd like to make a screen with a message that people will read before i continue with my instructions. I don't know what this is called but does anybody know how to create a screen with a written message (say on a black background) within a certain point in a video? (i am instructing how to do something but in the video i forgot to mention something very important).

Avidemux text overlay